Omron POWLI BN50S - Page 45

BN50S / BN75S / BN100S / BN150S / BN220S / BN300S
4
33
●
AC input plug selection (setting switch 7 , 8 )
…
Factory setting: Refer to the table below. (The values may vary
depending on the model.)
* Always use the BN50S/BN75S/BN100S with the switches in their original OFF/OFF state (factory
settings).
When replacing the AC input plug on the BN150S/BN220S/BN300S, change the settings
according to the table below.
See also
After changing the AC input plug, check the maximum allowable output values in the “AC
input plug” table in “2-3 Device connection procedure.” Page 12
1 2 53 4 86 7
ON
ON
DIP
BN150S BN220S BN300S
OFF OFF
15A (at shipment )
30A (at shipment ) 30A (at shipment )
(NEMA5-15P)
15A
(NEMA5-15P)
15A
(NEMA5-15P)
ON OFF
20A
(NEMA5-20P
NEMAL5-20P)
20A
(NEMA5-20P
NEMAL5-20P)
20A
(NEMA5-20P
NEMAL5-20P)
OFF ON -
(NEMAL5-30P) (NEMAL5-30P)
ON ON - -
50A
(NEMA5-50P)
Setting switch 7 Setting switch 8