What to do if Omron UPS status indicator shows blank and beeper sounds?
If the status indicator is blank and the beeper sounds at 0.5-second intervals, you likely have too many devices connected. Reduce the number of connected devices until the status indicator displays correctly.
What to do if Omron Powli BY35S UPS status indicator blinks and beeper sounds continuously?
If the status indicator blinks and the beeper sounds continuously, the output has stopped because the connection capacity has been exceeded. Turn off all power to the unit and connected devices, reduce the number of connected devices. Then, turn the power to the unit and connected devices back on and check whether the status indicator displays correctly.
Why does my Omron Powli BY35S switch frequently during normal power?
Frequent switching in your Omron UPS, even without a power failure, can be caused by variations in the input power or noise distorting the voltage waveform. Try changing the wall outlet to which the UPS is connected, positioning it away from equipment that consumes large power. Also, avoid connecting many devices to a plug strip or extension cord, especially if it's a long or thin cable.
How to fix Omron UPS display if it is abnormal?
An abnormal, unstable display with white lines or increased noise on your Omron UPS may be due to internal noise. Try grounding all devices connected to the UPS by using 3-pin plugs or connecting their Grounding Terminals to the Grounding Terminal of a wall outlet. Rearrange power cords if they are long or placed closely, and ensure the UPS and backed-up devices are not too close together. If the UPS or connected devices are in a metal rack, ground the rack itself.
What to do if Omron UPS does not operate?
If your Omron UPS doesn't operate, and the LED display remains off even when plugged in and switched on, first, ensure the AC input plug is securely connected to the power outlet. The AC Input Overcurrent Protection may be active. Disconnect all connected devices, push in the black AC input overcurrent protection button, and turn the UPS power switch back on. If the status indicator still doesn't display normally, there may be a problem with the UPS.
What to do if Omron UPS backup is not possible?
If your computer stops during a power failure when connected to the Omron UPS, the battery may not be sufficiently charged. Charge the battery for at least 12 hours by connecting the AC input plug of the UPS to a wall outlet and then test again.
Why Omron UPS does not turn ON?
The Omron UPS might not turn on if the input power supply voltage or frequency is abnormal. Check the voltage and frequency of the input power supply.
General| Capacity | 350VA/210W |
|---|---|
| Output Waveform | Simulated Sine Wave |
| Operating Temperature | 0-40°C |
| Warranty | 2 years |
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Outlets | 3 |
| Protection | Surge protection, overload protection, short circuit protection |
To Next Page
