Omron POWLI BN50S - Page 90

8.Using a contact signal
78
10.Xserve RAID connection procedure
Apple’s Xserve RAID can be controlled by changing the contact signal card settings.
* Cable: Connection cable (BUC28), sold separately
1. UPS connection procedure
(1) Turn OFF the unit’s power switch and remove the cover of the slot for “signal card addition” from
the rear of the unit.
See also
●
How to insert/remove the contact signal card
➛
Page 75
(2) Change the contact signal card’s JP2 to JP9 jumper settings (8 settings) to “SC05/06.”
(3) Change the JP10 jumper setting to “SC05XSR.”
(4) Insert the contact signal card into the UPS.
(5) Connect the BUC28 cable connector (female end) to the Xserve RAID serial port and turn the con-
nector fi xing screw clockwise to tighten it.
Connect the other end (male end) of the same cable to the contact signal card and turn the con-
nector fi xing screw clockwise to tighten it.
Change Jumper settings
(9 degits)
BUC28
cable
USB connector
USB
cable
Contact
signal card
8ÃiÀÛi,
8ÃiÀÛi
(6) Turn ON the power switches for the Xserve RAID and the UPS.