Omron Powli BU1002SW - Fan Replacement Procedure

52
6. Maintenance and Inspection
1
2
3
1
2
●
Replacement fan
For BU1002SW/ BU3002SW rear fan : Model BUF1002S
For BU3002SW front fan : Model BUF3002S
■
Fan replacement procedure
1.
Use a screwdriver to loosen (turn counter-clockwise) and remove the 3 cooling fan screws.
➀
Pull the cooling fan toward you to remove it.
➁
1
Loosen the
3 screws.
Fan replacement is complete.
4.
Insert the fan into the unit’s fan recess.
➀
Use a screwdriver to securely tighten (turn clockwise) the 3 removed screws.
➁
When doing so, make sure the cable does not become pinned under the fan cover.
3.
Insert the new fan connector until it clicks into place.
➂
The beep stops, and the "EF" status display lamp turns OFF.
2.
While pressing down on the tip of the fan connector
➀
, pull it toward you to disconnect it.
➁
The beep stops, and the error lamp turns OFF.
2
Fan recess
Fan
* Different screw locations for BU3002SW front fan.