18
3.Using the Unit
3. Press the O/I START button to
turn the unit off.
Note: If you forget to turn the unit
off, it will automatically shut
itself off after two minutes.
To Delete All Values in Memory
You cannot delete the stored readings partially, all the reading in
the unit will be deleted.
To delete stored readings, first press the MEM button. Then
while holding it down, press the O/I START button
simultaneously for about 2-3 seconds. All readings will then be
deleted.
Notes:
• After the reading have been deleted, the screen to the right of
the illustration above appears and Memory display flashes.
Release the buttons to return to the memory display.
• If the date and time are reset to a time before the most recent
measurement, the average value will be based on any
measurements taken after the date and time were reset.
However, you can still view the readings stored in memory.
HEM6021-E.book Page 18 Friday, July 22, 2005 11:08 AM
To Next Page
Loading...
Need help?
General
