10-5
10-2 Preparing for Operation
OMNUC G5-series AC Servomotors and Servo Drives User’s Manual (with Built-in EtherCAT Communications)
10
Operation
EtherCAT Status Indicators
Check the status of the status indicators.
If the RUN indicator will not turn ON or the ERR indicator will not turn OFF, refer to Status
Indicators on page 5-2 and check the status.
A
*1 : “ ” will flash when a Safety Input Error (Error No. 30.0) occurs.
“ ” does not flash on the display.
Warning occurs. Warning cleared.
Servo ON Servo OFF
+ Dot on right lights.
+ Dot on right lights.
Error occurs Error cleared
Warning code
(for 2 s)
Normal code
(for approx. 4 s)
Error Display
*1
Normal Display (LED Display Selection (3700 hex) set to 0)
The main error code flashes
as a decimal (example for an overload).
Warning Display
Main power supply
turned ON and EtherCAT
communications
established.
Main power supply
interrupted and EtherCAT
communications not
established.
The hexadecimal warning code and the
normal display are displayed alternately
(example for an overload).
To Next Page
Loading...
