Omron SYSMAC CS Series Operator's Manual

Connection with Application Programs Section 7-2
148
· If the FINS address set by the application program can not be changed,
[Disconnect the Simulator] and then change the node address of the net-
work communications unit in the [System Status] | [Settings] | [Network
Communications Settings] window.
Note The CX-Simulator generates a FINS network address automatically when
[Connect]. Use the FINS network address displayed when [Connect] as that
to be used by the application program.
· If multiple networks exist, the routing table for FinsGateway must be
changed.
4. Turn the Run mode of the Ladder Engine to [Continuous Run] in the [CX-
Simulator Debug Console] window.
5. Execute the application program to check its operation.
Note When changing the contents of I/O memory areas of the Ladder Engine for
debugging application programs, use the CX-Programmer.
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr

Omron SYSMAC CS Series Specifications

General

Brand	Omron
Model	SYSMAC CS Series
Category	Controller
Language	English