Appendices
A - 38
NX-series Communications Interface Units User’s Manual (W540)
This sample receives data that was sent from the serial communications device.
This programming sample is for the example given in 7-4-2 Example of Receiving Data o
n page 7-16.
The processes in the table in 7-4-2 Example of Receiving Data o
n page 7-16 correspond to the com-
ment process numbers in the ST program as follows:
A-4-4 Programming Sample 3: Receiving Data
Procedure
Step number in example of
receiving data
Process
Comment process number in ST
program
--- Skipping reading receive data when a
reception error occurs.
(1)
1 Receiving A to Z ---
2 Inputting string from A to T (2)
3 Input response for A to T (2)
4 Inputting string UVWXYZ (2)
Notification of end detection (3)
5 Input response for UVWXYZ (2)
To Next Page
Loading...