Onan 15.0MDJF-3CR User Manual

1------- 2 9/32"-----.1°1
7
~
_~~~~J
The raw water s ide of the heat exchanger
is protected from corrosion by zinc pencil
mounted on pipe plugs in one end of the
heat exchanger. Inspect the pencil at least
every 2 months and replace if deteriorated
to less than 1/2 original size.
SPECIFICATION A THROUGH C
ZINC PENCIL
FIGURE 23. SERVICING PROCEDURES
GENERATOR SET ROU1"INE CHECK CHART
Before generator set is put in operation, check all
components for mechanical security. If any abnormal
condition, defective part or operating difficulty is
detected, repair or service as required. The generator
set should be kept free of dust, dirt and spilled oil or
fuel. Be sure proper operating procedure is followed.
WHAT
TO
CHECK
HOW
TO
CHECK
PRECAUTIONS
Engine oil
Check level (should be at full mark
on
oil indicator).
Add
oil as necessary to bring level to full
mark.
Engine fuel
Check level in tank.
See that fuel line is properly connected.
Engine radiator
.ChE!ck ventilating openings and
water level.
Remove any obstructions.
Keep radiator full.
Connecting cables
Check for proper connections.
Check for physical damage.
Tighten connections.
--:-.
Replace damaged connectorS.
. ..
Battery
Check electrolyte level.
Keep level above plates ..
Add only approved water as necessary.
!~
26

Onan 15.0MDJF-3CR Specifications

General

Brand	Onan
Model	15.0MDJF-3CR
Category	Portable Generator
Language	English