Onan 6GO-F User Manual

OPERATION
Continuous overloa.ding of the gene;ratorwill cause the generator tem-
perature to rise to a. dangerous point. and lead· to earlY failure of the
windings. If the main line fuse should blowout. or the plant oircuit
breaker open, remove the cause of overloa~g·betoreagain oonnecting
the load to the plant. On .the three phase plant, it part o~ the load
is single phase l the total load on any one "leg" Should not exceed one
third the total capacity of the generator. On the 115/230 volt. plant,
divide the load asclosaly as possible between the two circuits when
using 115 volt current. Confine the load on each 115 volt circuit to
not more than 2500 watts.
STOPPING THE PLANT.- Throw the main line switch or the plant circuit
breaker to the OFF position, to disconnect the load. Press the STOP
button firmly. The ignition switch must be at the ELECT. START posi-
tion, as pressing the STOP button will have no effect if the switch is
at the HAND START posit.ion. In an emergency, if the stop circuit fails
to work, turn otf the fuel supply. The plant will stop when the supply
of fuel in the carburetor is exhausted. .
11

Onan 6GO-F Specifications

General

Brand	Onan
Model	6GO-F
Category	Inverter
Language	English