Shifted Macros
You can install a Shifted Macro on any key, except for the device
keys (TV, VCR, SAT and DVD), the M (MAGIC) key, and the
NUMBER keys.
If for example, you want to program a shifted Macro on the POWER
key, simply press M (MAGIC) once then the POWER key during
step 3.
Now everytime you press M (MAGIC), then the POWER key, the ONE FOR
ALL will turn off your TV, VCR and DVD Player.
• To erase the Shifted Macro from the POWER key press:
M* 9 9 5 M POWER key M*
* Here you must press and hold down the M (MAGIC) key until the red LED
underneath the POWER key blinks twice (the red LED will blink once then
twice).
- Each MACRO can consist of a maximum of 15 key strokes.
- Make sure that you program a Macro on a spare key that you don’t use in
any mode.
- Once you program a Macro on a specific key, the sequence will work
regardless of the mode (TV, VCR, SAT, DVD and AMP) you are using.
- To avoid accidental recordings with the ONE FOR ALL 5, you must press the
Record key twice to begin recording. Because of this, you cannot assign a
Macro or Shifted Macro to the Record key.
- If you had to hold down a key for a few seconds on the original remote
control to get a function, this function may not work in a macro on your
ONE FOR ALL remote.
- If you program a Macro on a key, the original function will become shifted
(excluding CH+/- and VOL+/- keys). Press M (MAGIC) key then the key to
access it. If you place a Macro shifted on a digit key, access the original
function by pressing the M (MAGIC) key twice and then the digit key.
- If a Shifted Macro is placed on the Channel and Volume keys then the
Colour and Brightness feature will be sacrificed.
Extra Features
WWW.ONEFORALL.COM 13
To Next Page
Loading...
Need help?
General
