One for All Universal remote User Manual

Before you start:
- Make sure your original remote control is working correctly.
- Make sure neither your ONE FOR ALL, nor your original remote control
is pointing at your device.
Example: To copy the “mono/stereo” function from your original TV
remote onto the ”Red”key of your ONE FOR ALL 5.
1 Place both remote controls (the ONE FOR ALL 5 and your
original) on a flat surface. Make sure the ends which you
normally point at your device are facing each other. Keep
the remotes at a distance of 2 to 5 cm.
2 Press and hold down the M (MAGIC) key
until the red LED underneath the POWER key
blinks twice (the red LED will blink once
then twice).
3 Press 9 7 5 (the red LED will blink twice).
4 Press the device key (on the ONE FOR ALL remote) to
select the mode to which you want to copy the learned
function (Example: TV key).
5 Press the key (on the ONE FOR ALL remote)
where you want to place the learned function
(Example: ”Red” key). The red LED will
flash rapidly.
6 Press and hold the key (on your original remote)
that you want to copy until the red LED blinks twice
(Example: “mono/stereo” key).
7 If you want to copy other functions within the same mode, simply
repeat steps 5 and 6 pressing the next key you want to copy by
learning.
8 To exit the learning mode, press and hold down
the M (MAGIC) key until the red LED blinks twice.
9 Learning is mode specific. To access your learned function,
press the appropriate device key first.
The Learning Feature
(How to copy functions from your original working remote
onto the ONE FOR ALL5)
Important notes:
- The ONE FOR ALL 5 can learn approximately 25 – 40 functions.
- You can replace a learned function by placing another learned function on
top.
- Upon changing the batteries, your learned functions will be retained.
x2
8 WWW.ONEFORALL.COM

One for All Universal remote Specifications

General

Brand	One for All
Model	Universal remote
Category	Universal Remote
Language	English