46
Use VOL+ (or VOL-) to raise (or lower) the
audio turntable’s audio volume (if applicable).
Press MUTE once to turn the audio turntable’s
audio off or on (if applicable).
Use the keypad (1 ~ 9 and 0) to
directly select tracks. If the original
remote control required pressing an
Enter key to select a track, also press
the ENTER key after the track number
(e.g., 1-2 -ENTER).
Use the transport keys to control
your audio turntable (if applicable).
After programming, press M1 ~ M3 once to
run a desired macro (see Using Macros on
page 34).
After programming, press L1 ~ L4
once to activate a learned function.
See Using Learning on page 29.
Use to turn on or off the key backlight.
When this feature is activated, keys will
remain backlit for 5 seconds after the last key
press.In the setup mode, backlighting
will remain on for 30 seconds.
Use SET for all programming sequences.
To Next Page
Loading...
