8 WWW.ONEFORALL.COM
Search Method
—> If your device does not respond to the URC-9040 after you have tried all
the codes listed for your brand.
—> If your brand is not listed at all.
The Search Method allows you to scan through all the codes contained
in the memory of the URC-9040.
Example: To search for your TV code (on the TV key):
1. Switch ON your television (not on standby) and aim your URC-9040 at your TV.
2. Press and release the TV key.
3. Press and hold down REWIND + FASTFORWARD simultaneously
until the URC-9040’s LED (red light) blinks twice (the LED will blink
once and then twice).
4. Press 9 9 1. The LED will blink twice.
5. Press 1 to scan through all TV codes. *
6. Next, press POWER.
7. Aim the URC-9040 at your Television. Now press CH+ over and over,
until your Television turns off (every time you press the CH+ key the
URC-9040 will send out a POWER signal from the next code contained
in the memory). You may have to press this key many times
(up to 150 times) so please be patient. If you skip past a code,
you can go to the previous code(s) by pressing the CH- key.
Remember to keep pointing the URC-9040 at your Television
while pressing this key.
8. As soon as your television turns off, press OK to store the code.
(*) to scan through other device types:
- Most TV’s do not switch on pressing the POWER key. Please try pressing a “number” key
or the “TV-text off” key to switch your TV back on.
- If you cannot control your Television properly, please continue the Search Method, you may
be using the wrong Code
.
- To search for the code for another device follow the instructions above only press the appropriate
device key instead of TV during step 2 and the appropriate number during step 5.
Setting up the URC-9040
Press: to scan through codes for:
Set-Top-Box or Satellite Receiver or Cable Converter
Television
DVD player/recorder or PVR (codes achieved by code upgrade)
Amplifier or Amp./Tuner or Miscellaneous
To Next Page
Loading...
