6 WWW.ONEFORALL.COM
How to set up the URC-9040 to control your PC
The URC-9040 PC Media Remote with OFA Media Centre allows you to control your digital content and
access it on your PC or on your home entertainment system, via the Command Center. The Command
Center connects to your PC by a USB cable.
NOTE: - The antenna of the RF receiver should be placed in the upright position!
- This product is not intended to be used with any USB extension cable!
To set up your Command Centre with your PC and install the OFA PC Media Centre
application, simply insert the setup CD supplied in the package into your PC,
select the language, and follow the on screen instructions.
IMPORTANT:
You do not need to program a device code into the URC-9040 PC Media Remote
with OFA Media Centre to control the Command Center. However, it is possible that someone else in your
building or complex may also have a URC-9040 Media Remote with OFA Media Centre. Therefore so
the URC-9040 remote contains 3 different addresses for the Command Center, which you can cycle
between to avoid conflicting signals.
NOTE: If more than 10 seconds pass between key presses, the URC-9040 remote
exits programming.
To change the Command Center address:
1. Press PC.
2. Press and hold down REWIND + FASTFORWARD
simultaneously until the URC-9040’s LED (red light) blinks twice
(the LED will blink once and then twice).
3. Press 41 (address 1), 42 (address 2), or 43 (address 3) to change
the address. The LED will light up twice.
NOTE: If the power key displays a long blink, the entry is invalid. Repeat steps 1 through 3.
NOTE: You must also change the address on the OFA Media Centre application to match the address
setup on your URC-9040.
Note the PC address being used below:
Setting up the URC-9040
or
>
or
>
To Next Page
Loading...
