Onean TWIN - Use and Configuration: Controller Overview; Controller Overview and Activation; Controller Configuration Menu

TWIN USER’S MANUAL
13
04
uSe and conFiguration oF the equiPMent
b) diSconnection
Avoid pulling from the cable, always pull
from the connector body.
c) iMPortant
Always supervise the charge, do not leave
the battery unattended while charging.
• The battery does not need to be fully discharged before charging. A
Lithium Ion battery doesn´t have memory effect. This means that
the maximum energy capacity won´t be aected if it´s charged after not
being fully discharged.
• Make sure that the battery does not remain connected to the
charger after the charge has been completed.
• Always remember to close the battery rubber connector covers
before use.
• The temperture use for the battery must always remain between 0 ºC y
60 ºC (32 ºF y 140 ºF).
• Extreme temperatures will aect the battery life, especially during
charge. Avoid charging the battery while being exposed to direct sunlight
or extreme high or low temperatures. The charge is recommended to be
carried out with temperatures (between 10 ºC y 45 ºC / between 50 ºF y
113 ºF).
• Do not overdischarge the battery. Do not continue riding once the
power starts to decrease and the LEDs on the top bar begin to blink, this
has been proven to decrease the battery’s capacity over time. This is an
extra energy resource which must be used only for emergencies.
4.2. wireLeSS controLLer
To activate the board you must press on the drop. The power of the Jet will
depend on the amount of pressure exerted on the drop.
4.2.1. controLLer conFiguration
Through the wireless controller you can set the maximum power for the Jet
and also adjust dierent proles.
In order to access the configuration menu, you must stick to the following
indications:
1. With the controller totally off (no LEDs ) place the drop over the logo.
SYNC BATTERY
Drop
Sync
Controller
battery
Board Battery
Power
Indicators
SYNC BATTERY
1
Connector
body
Cable