OnePlus 12 - Page 29

function is good;
10
Super Vooc
Charger
Use the original OnePlus adapter and USB cable to charge. If the interface
shows “PASS” and jumps to the next test, the function is good;
11
Headset in-out
plug test
Enter the headset test interface，when it is recognized that the headset is
plugged in, it is a good product
12
Sensor Self-test
and Calibration
When the phone enters into the Sensor self-calibration interface, the phone
must be placed on the desk flatly. Then click the first calibration item. After the
test is passed, it will automatically jump to the next test item;
13
Gyroscope
Take the mobile phone to draw the "8" word graphic. If the interface shows
“PASS” and jumps to the next test, the function is good;
14
MSensor
Shake the phone from the left to the right side. If the interface shows “PASS”
and jumps to the next test, the function is good;
15
Proximity Test
Use the palm to cover the light sensor hole, and the screen will turn green
from black. If the interface shows “PASS” and jumps to the next test, the
function is good;
16
Button test
Press the power key and volume key one by one. If keys can be pressed
normally and the interface jumps to the next test, the function is good;
17
Finger print Auto
Test
If the interface shows “PASS” and jumps to the next test, the function is good;
18
Media test
Click the “20-4K（-3db)signal” to test the sound of the media function for 5s.
If there is no silence, weak sound, noises, and breaking sound, the interface
shows “PASS” and jumps to the next test, the function is good;
19
Call test
If the phone has been installed with the operator's SIM card, dial the
corresponding operator's phone number. If no card is installed, call the 112 to
test (Calling the Operator is recommended). If the call can be performed
normally and the receiver is without noises or weak sounds, the function is
good;
20
NFC test
Connect the NFC card reader to the computer. After the phone automatically
selects the SIM1 simulation（5s）, move the phone’s rear camera area close
to the NFC card reader, and the card reader’s signal light changes from red to
green with a beep sound.
After the above 20 items are tested, they will prompt to the test result interface. If the test PASS, project will
show “√”; If the test FAIL, project will show “×” as shown below.