11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • sales@onicon.com
F-3100 Flow Meter Manual 11/17 - 0670-9 Page A-1
Step 1
Open cover. Slide
cover off to the right,
if desired.
Section 1: Removing the Transmitter
Before attempting to remote mount the transmitter, disconnect power at the source.
Step 4
Remove electrode
and coil connectors
from their sockets.
Step 5
Remove electrode and coil wires
from connectors and set aside.
Step 6
Remove mounting screws from
the bottom of the enclosure.
Screws do not need to be fully
removed.
Step 7
Carefully separate the electronics
enclosure from the sensor body.
As the two come apart, feed the
sensor wires through the opening
in the bottom of the enclosure.
Step 3
Remove power
connector from its
socket. Remove wires
from the connector
and set aside.
Step 2
Open compartment
to expose power
connection.
Field Remote Mounting the Transmitter
Wiring Instructions
To Next Page
Loading...
