11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • sales@onicon.com
F-3100 Flow Meter Manual 11/17 - 0670-9 Page A-2
Step 1
Remove the cover and
circuit board from the
remote mount junction
box.
Section 2: Installing the Remote Mount Junction Box
Step 2
Feed the cales through
the holes in the bottom
of the junction box
and mount it in place.
Step 3
Re-install the cir-
cuit board.
Step 4
Attach the cables to
the terminal blocks
as shown.
Step 5
Install the remote
mount cable through
the strain relief
supplied with the
junction box.
Step 8
Re-install the
cover.
(Note: Each wire is labeled with
a number that corresponds to a
terminal location.)
Step 7
Cables should
be connected
as shown.
Remote
transmitter
cable
Sensor
cables
Step 6
Install the remote
mount cable to the
numbered terminal
block positions.
To Next Page
Loading...
