Onkyo A-8067

A-8067
PRECAUTIONS
1. Replacing the fuses
For continued protection against risk fire, replace only with same type and same rating fuse.
CIRCUIT NO. PARTS NO. DESCRIPTION
F901 252051 6A (ST-6), Primary fuse (120V model)
F901 252076 3.15A-SE-EAK, Primary fuse (220V, 120V/220V model)
F701 25 2070 1 A-SE-EAK, Secondary fuse (220V model)
2. Replacing the lamp
This unit uses the lamp listed below.
CIRCUIT NO. PARTS NO. DESCRIPTION
PL701 210172 PLI4V0.06AW-2.0
3. Insulation resistance mesurement (Only U.S.A. model)
Connect the insulating-resistance tester between the plug of power supply cable and the terminal GND on the back panel.
Specification; SOOV more than 1OM22.
4. Voltage selector (rear panel)
Worldwide models are equipped with a voltage selector to conform with local power supplies. Be sure to set this switch to
match the voltage of the power supply in your area before turning the power switch on. Voltage is changed by sliding the
groove in the switch with a screwdriver or similar instrument to the up or down position. Confirm that the switch has been
moved all the way to the up or down before turning the power switch on. If there is no voltage selector switch on the unit
you have purchased, it can only be used in areas where the power supply voltage is the same as that of the unit.
220V ~ | 220V ~
at AC 220V at AC 120V
"| 120V ~ | 120V ~
MAIN AMPLIFIER ADJUSTMENT
Set the all control knobs to standard position
Standard knob position
INPUT SELECTOR CD
CARTRIDGE SELECTOR MM
REC. SELECTOR OFF
MODE STEREO
MUTING OFF
SUBSONIC FILTER OFF
BALANCE Center
VOLUME Minimum
LOUDNESS OFF
BASS DEFEAT
TREBLE DEFEAT
SPEAKERS A
IDLING CURRENT ADJUSTMENT
1. Connect the DC voltmeter between I;p and Vez terminals.
2. Adjust the voltage to 1SV + SmV with semi-fixed resistor of R531 and R532.
NOTES.
Adjust after switching on for 5 minutes.
VOLUME .............. Minimum
LOAD ................ Open