Onkyo BD-SP807

41
FUNCTION SETUP
EN
*2)
The table below describes the available video resolution when “Progressive Mode” is set to “Auto1” or “Auto2”:
*3)
An individual picture on the TV screen is called “Frame”, which consists of two separate images called “Field”. Some
pictures may be blurred at the auto setting in “Still Mode” setting due to their data characteristics.
• “Quick” menu consists of the setting menus frequently used, and they are accompanied with .
• If the picture is not output properly to the TV because of “HDMI Video Resolution” or “Component Output” setting,
press and hold [B (play)] on the front panel for more than 5 seconds. Both settings will be reset to the default
automatically.
• For “HDMI RGB Setting”, select “Enhanced” if the black-white contrast is not clear. The setting is effective only for HDMI
RGB output.
• Even if “HDMI Video Resolution” is set to “1080p24”, for the BD that is not recorded by 1080p24 frame or for DVD, a
video resolution supported by the disc and the display device will be output instead of 1080p24 frame.
• If “Component Output” is set to “480i/576i”, “16:9 Squeeze” in “TV Aspect” is not available.
• If HDMI is connected, for video resolution for the component output, you can only select video resolution that
currently output from HDMI OUT jack or “480i/576i”.
• If the video resolution for the component output and HDMI video resolution does not match, the video resolution for
the component output will be switched to “480i/576i”. VIDEO OUTPUT (COMPONENT) jacks may not output any
signals depending on the disc material.
• If you play back copy-protected DVD-Video, “480p/576p” signal will be output from the VIDEO OUTPUT (COMPONENT)
jacks, when “Component Output” is set to “720p” or “1080i”.
• The setting items which are not available with current situation of this unit will be displayed in gray and you cannot
select the items.
• Even if “HDMI Select” is set to “YCbCr”, if the display device does not support YCbCr, RGB will be output.
• If “HDMI Video Resolution” is set to “Source Direct”, “1080p” or “1080p24”, you cannot set “Component Output”.
Output resolution
Media Material resolution 480i/576i 480p/576p 720p 1080i 1080p 1080p24
BD-video 480i /576i ⳯⳯⳯⳯⳯ ]
AVCHD 480p/576p ⳯⳯⳯⳯⳯ ]
720p ⳯⳯⳯⳯⳯ ]
1080i ⳯⳯⳯⳯⳯ ]
1080p ⳯⳯⳯⳯⳯ ]
1080p24 ⳯⳯⳯⳯⳯⳯
DVD-video 480i/576i ⳯ cccc ]
DivX
®
480i /576i ⳯ cccc ]
480p/576p ⳯⳯⳯⳯⳯ ]
720p ⳯⳯⳯⳯⳯ ]
1080i ⳯⳯⳯⳯⳯ ]
1080p ⳯⳯⳯⳯⳯ ]
c : available ⳯ : not available ] : not exist