Onkyo CR-N7 User Manual

42
Naming Preset Channels
You can name FM/AM preset channels.
After you select the preset channel to name, execute
“Entering a name” as described below.
You can enter up to eight characters per name.
What characters can be entered?
You can enter the following characters:
If the unit is not in “Name In” mode, execute Steps 1 and
2 in “Entering a Name,” then follow the steps below.
1 Press / repeatedly until the
character you wish to correct or erase
flashes.
2 When correcting
Enter the desired character (or title)
following Steps 3 and 4 in “Entering a Name”
in the left column.
When erasing
Press EDIT/NO/CLEAR on the unit.
Notes:
• If you press and hold EDIT/NO/CLEAR for more
than two seconds, the CD receiver returns to the pre-
vious indication without erasing characters.
• To continue entering characters, execute Step 3 in the
left column. To complete the operation, execute Step
5.
Naming a Preset Channel
Entering a Name
1
Press EDIT/NO/CLEAR and turn
MULTI JOG until “Name In?”
appears in the display.
2
Press MULTI JOG.
3
Press DISPLAY repeatedly until
the character type you wish to
enter appears in the display.
You can select one of the following char-
acter entry modes:
•“A” for capital letters
•“a” for small letters
•“1” for numbers and symbols
1
53
2, 4
Display
The character type appears.
4
Turn MULTI JOG to select the char-
acter, then press it to enter.
Repeat this step for the next character. If
you wish to change the type of charac-
ters, repeat Step 3, then proceed with this
step.
To cancel the characters, press and hold
EDIT/NO/CLEAR for more than two
seconds.
5
Press YES/MODE after you enter
all the characters.
You will see the “Complete” message
that indicates the entry of characters is
completed.
Correcting and Erasing a Character
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
a b c d e f g h i j k l m n o p q r s t u v w x y z
0 1 2 3 4 5 6 7 8 9
_ @ ' < > # $ % & * = ; : + - / ( ) ?
! ’ ” , . (space) (insert)

Onkyo CR-N7 Specifications

Power

power supply	AC 230–240 V, 50 Hz
power consumption	68 W
stand-by power consumption	0.3 W

Audio Inputs and Outputs

analog inputs	LINE, TAPE, HDD
digital outputs	Optical: 1
analog outputs	TAPE, HDD

Amplifier Specifications

power output	14 W + 14 W (8 Ω, 40 Hz–20 kHz THD, 0.4%)
dynamic power	26 W + 26 W (4 Ω, JEITA)
damping factor	25 (8 Ω)

Tuner Specifications

fm tuning frequency range	87.5 MHz–108 MHz
am tuning frequency range	522 kHz–1611 kHz
stereo separation	40 dB (1 kHz)

CD Specifications

frequency response	10 Hz–20 kHz
audio dynamic range	92 dB
thd (total harmonic distortion)	0.009 %

Weight and Dimensions

dimensions	205 W x 147 H x 356 D mm
weight	4.3 kg