DV-SP500
ADJUSTMENT PROCEDURE-2
Remove the servo mechanism.
Remove a Spacer for height adjustment
attached to the back side (shaded area)
of the Servo Mechanism (Float Base) with
nippers.
Cautions:
Because there is not a Spacer for height adjustment in
adjustment after the second time, will keep it at need.
(This parts is Traverse mechanism exclusive use of a model
for 2001 years)
Put a spacer between a Tangential (or Radial) adjustment
screw and Mechanism Base and turn each screw to adjust
the height.
Note:
Turn the Short switch to Short side when
removing the Pickup Flexible Cable.
START
MECHANISM ADJUSTMENT
Tangential and Radial Height Coarse Adjustment
1
Servo Mechanism
7.3mm
Turn a flat side
into bottom
Spacer for Height adjustment
Float Base
To Next Page
Loading...
