27
Changing the display
Press DISPLAY.
Each time you press DISPLAY, the screen changes as follows:
When an input source other than FM or AM is selected
FM/AM + Listening
mode
FM/AM frequency +
Preset no.
Input source +
Listening mode
(or Multich)
Input source +
volume
Program format*
Controlling the brightness of the lights on the
AV Receiver
Press DIMMER.
Each press of the button changes the brightness as follows:
→ The display becomes less bright.
↓
The display is dimmed.
↓
The display becomes bright.
Using the sleep timer (remote controller only)
Press SLEEP.
“Sleep 90 min” appears in the multipurpose display for about 5
seconds, which means the AV Receiver will turn off and enter
standby mode in 90 minutes. Also the SLEEP indicator is lit in the
display while the sleep timer is on.
Press DISPLAY once to initiate the program format display.
Pressing the button again switches the display to the other display.
* If the input signal does not have a program format, then this
will be skipped. The format display returns to the previous
display after the format display has lasted for about three
seconds (
)
When FM or AM is selected as the input source
SLEEP indicator
Each press of the button makes the remaining time shorter by 10
minutes.
Checking the remaining time
Press SLEEP while the sleep timer is On.
The remaining time is displayed.
If you press SLEEP while the remaining time is displayed, the
remaining time is reduced by 10 minutes.
Canceling the sleep timer
Press SLEEP repeatedly until the SLEEP indicator goes off.
Various functions common to all the sources
DISPLAY
DIMMER
DIMMER
SLEEP
To Next Page
Loading...
Need help?
Amplifier Section
