31
Input source Analog PCM*
1
Dolby Digital DTS
signal format
Source software Tape, CD, Video CD, DVD video, LD
*2
CD
FM/AM DVD Video, DVD Video,
Listening mode Video cassette tape DVD Audio Multi channel Stereo LD*
2
Direct ●●
Stereo ●●●●●
PL II Movie ●● ●
PL II Music ●● ●
Dolby D ●
DTS ●
Orchestra ●●
Unplugged ●●
Studio-Mix ●●
TV Logic ●●
All Ch St ●●
*
1
Only Stereo or Direct can be selected when the PCM source has been recorded with a sampling rate 96 kHz.
*
2
If you have an LD player with AC-RF output, connect it via a AC-RF demodulator to one of the HT-R500’s DIGITAL INPUT terminals.
Enjoying the listening modes
The input sources and available listening mode
The listening modes that can be selected are variable depending on
the signal formats employed with the input sources.
Notes
• Only “Stereo” (“Stereo” or “Direct” for PCM/Analog source)
can be selected when the speaker configuration is set to
“Speaker 2ch”, when headphones are used, or when speakers B
is selected.
• The listening mode cannot be selected when “Multich” is
selected.
• You can select “Orchestra”, “Unplugged”, “Studio-Mix” and
“TV Logic” only when the speaker configuration is set to
“Speaker 4ch” or “Speaker 5ch”.
• If you select “Orchestra”, no sound is reproduced from the
center speaker even when the speaker configuration is set to
“Speaker 5ch”.
To Next Page
Loading...
Need help?
Amplifier Section
