Onkyo HT-R695 User Manual

9
> Specifications > Settings > Listening Modes > Playback Function > Basic Manual
Troubleshooting | Appendix
2� Speaker
You can make changes to the connection environment of the speakers and change the
volume level. Settings are automatically configured if you use AccuEQ Room Calibration.
This setting cannot be selected if headphones are connected or audio is output from the
speakers of the TV.
■ 1� Configuration
Setting Item Default Value Setting Details
Speaker
Channels
5.1.2 ch Select "2.1 ch", "3.1 ch", "4.1 ch", "5.1 ch", "6.1
ch", "7.1 ch", "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", or
"5.1.2 ch" to suit the number of speaker channels
connected.
Subwoofer Yes Set whether a subwoofer is connected or not.
"Yes": When subwoofer is connected
"No": When subwoofer is not connected
Height Speaker Bundled Dolby
Speaker
Set the speaker type if height speakers are
connected to the SURROUND BACK or HEIGHT
terminals.
Select "Front High", "Top Front", "Top Middle",
"Top Rear", "Rear High", "Dolby Speaker (Front)",
"Dolby Speaker (Surr)", or "Bundled Dolby
Speaker" according to the type and layout of the
connected speakers.
•
If an item cannot be selected even though
connection is correct, check that the settings
in "Speaker Channels" matches the number of
connected channels.
Zone Speaker No Set the connection of speakers to Zone 2 speaker
terminals.
"Zone 2": When speakers are connected to Zone 2
speaker terminals
"No": When speakers are not connected to Zone 2
speaker terminals
Setting Item Default Value Setting Details
Bi-Amp No Set whether the front speakers are bi-amp
connected.
"No": When front speakers are not bi-amp
connected
"Yes": When front speakers are bi-amp connected
•
This item will be fixed to "No" when the "Zone
Speaker" setting is "Zone 2".
•
This setting cannot be selected when surround
back speakers or height speakers are installed.

Onkyo HT-R695 Specifications

General

Brand	Onkyo
Model	HT-R695
Category	Receiver
Language	English