4 When you've finished making the settings, press
ENTER.
Surround Back/Front High Surround Back
Perform the "Speaker Setup" according to your
speaker configuration:
- Powered Zone 2 (# page 43)
- Surround Back/Front High (# page 44)
When an optional unit is connected to the
UNIVERSAL PORT jack on the AV receiver, the
optional unit setting may appear on the speaker
setting menu.
5 Use 1/¥ to select "Audyssey Quick Start" or
"Audyssey 2EQ Full Calibration".
6 Press ENTER.
Audyssey 2EQ® Room Correction and Speaker Setup
starts.
Test tones are played through each speaker as
Audyssey 2EQ Room Correction and Speaker Setup
runs. This process takes a few minutes. Please
refrain from talking during measurements and do
not stand between speakers and the microphone.
Do not disconnect the speaker setup microphone
during Audyssey 2EQ Room Correction and Speaker
Setup, unless you want to cancel the setup.
If you select "Audyssey Quick Start", you will go to
step 9.
7 Place tile setup microphone at tile next position,
and then press ENTER.
Audyssey 2EQ performs more measurements. This
takes a few minutes.
8
When prompted, repeat step 7.
10Use,/, to select a target, and use _/_ to change
the setting.
Alter the results of Audyssey 2EQ have been saved,
the menu will display the "Audyssey" (_ page 48),
"Dynamic EQ" (_ page 48), "Dynamic Volume"
(_ page 49) settings.
• When "Audyssey Quick Start" has been used for
measurement, "Audyssey" cannot be selected.
• These settings are applied to all input selectors.
11Press ENTER.
12Disconnect the speaker setup microphone.
!
• You can cancel Audyssey 2EQ Room Correction and Speaker
Setup at any point in this procedure simply by disconnecting the
setup microphone.
• Do not connect or disconnect any speakers during
Audyssey 2EQ Room Correction and Speaker Setup.
• If the AV receiver is muted, it will be unmuted automatically
when Audyssey 2EQ Room Correction and Speaker Setup
starts.
• Changes to the room after Audyssey 2EQ Room Correction and
Speaker Setup requires you run Audyssey 2EQ Room
Correction and Speaker Setup again, as room EQ characteristics
may have changed.
9 Use 1/¥ to select an option, and then press
ENTER.
2EQ:Auto Setup
- Review Speaker Configuration -
Subwoofer Yes
Front Yes
Center Yes
Surround Yes
"_ Front High No
Surround Back Yes
Surround Back Ch 2oh
Cancel
The options are:
Save:
Save the calculated settings and exit
Audyssey 2EQ Room Correction and Speaker
Setup.
Cancel:
Cancel Audyssey 2EQ Room Correction and
Speaker Setup.
• You can view the calculated settings for the speaker
configuration, speaker distances, and speaker levels by
using "_/_.
ED
31
To Next Page
Loading...
Need help?
General
