Onkyo HT-R990 User Manual

m Operating on the AV receiver
Input selector buttons
ZONE 2 OFF MASTER VOLUME
Adjusting the Volume for Zone 2
m Operating on the remote controller
1 PressZONE2.
2 UseVOL,/, to adjust tile volume.
gl i
1
To turn on Zone 2 and select an input source, press
ZONE 2 followed by an input selector button
within 8 seconds.
Zone 2 turns on, the Z2 indicator lights on the
display.
To select AM or FM, press the TUNER input selector
button repeatedly.
To select the same source as the main room's, press
ZONE 2 repeatedly until "Z2 Selector: Source"
appears on the display.
To turn off Zone 2, press OFF.
The zone is turned off.
m Operating on the remote controller
To control Zone 2, you must press ZONE2 on the remote
controller first.
......../ ..... ; i _RECEIVER
(7)/ @ ,,,_;_ y ZONE2
i _ n pu t
selector buttons
i
v ¢,_ @ @
_- --MUTING
--VOL _/_
1
2
PressZONE2 and then press ORECEIVER.
Zone 2 turns on, the Z2 indicator lights on the
display.
To select an input source for Zone 2, press ZON E2,
followed by an input selector button.
To select AM or FM, press the TUNER input selector
repeatedly.
• You cannot select different AM or FM radio stations for
your main room and Zone 2. The same AM/FM radio
station will be heard ill each room.
3 To turn off Zone 2,pressZONE2 followed by
ORECEIVER.
m Operating on the AV receiver
1 Press ZONE 2 (the Z2 indicator on the display
flash).
2 Use MASTER VOLUME control within 8 seconds
to adjust the volume.
If your Zone 2 speakers are connected to a receiver or
integrated amp in Zone 2, use its volume control to adjust
the volume.
Muting Zone 2
m Operating on the remote controller
1 Press ZONE2 followed by MUTING.
• To unmute, press ZONE2 followed by MUTING again.
• Only analog input sources are output from the 7ONE 2 MNE
OUT I..JR jacks and ZONE 2 I.]R terminals. Digital input
sources are not output. If no sound is heard when an input source
is selected, verify that the source is connected to an analog input.
• While Zone 2 is on, RI functions will not work.
• You cannot select different AM or FM radio stations for your
main room and Zone 2. The same AM/FM radio station will be
heard in each room. Namely, if you have selected an FM station
for the main room, that station will also be output in Zone 2.
• When you have selected NET or USB as the input selector, the
last selector selected will be set for both Main room and Zone 2.
• Zone 2 can also be unmuted by adjusting the volume.
• When Zone 2 is activated and its input selector is selected, the
power consumption of standby mode slightly increases.
• When setting the AV receiver to standby mode while Zone 2 is
active, the Z2 indicator is dimly lit.
En
60

Onkyo HT-R990 Specifications

General

Brand	Onkyo
Model	HT-R990
Category	Receiver
Language	English