i! ! !!!!!!!!!!!!!!!!!!!
The AV receiver can upconvert component video and
composite video sources for display on a TV connected to
the HDMI OUT. However, if the picture quality of the
source is poor, upconversion may make the picture worse
or disappear altogether.
In this case, try the following:
1 If the video source is connected to a component
video input, connect your TV to the
COMPONENT VIDEO OUT.
If the video source is connected to a composite video
input, connect your TV to the MONITOR OUT V.
2 On the main menu, select "Input/Output Assign",
and then select "Component Video Input"
(_ page 43).
If the video source is connected to COMPONENT
VIDEO IN 1, select the relevant input selector, and
assign it to "INI".
If the video source is connected to COMPONENT
VIDEO IN 2, select the relevant input selector, and
assign it to "IN2".
If the video source is connected to a composite video
input, select the relevant input selector, and assign it
to " "
En
72
To Next Page
Loading...
Need help?
General
