6
En
Update procedure
1
Connect a USB device to your PC. If
there is any data in the USB device,
remove it first.
2
Download the firmware file from the
Onkyo web site. The file name is as
follows:
ONKAVR****_************.zip
Unzip the downloaded file. The
following three files are created:
ONKAVR****_************.of1
ONKAVR****_************.of2
ONKAVR****_************.of3
3
Copy the extracted files to the USB
device. Be careful not to copy the zip
file.
4
Remove the USB device from your PC
and connect it to the USB port on the
AV receiver.
5
Make sure the AV receiver and TV are
turned on.
If the AV receiver is in standby mode,
press 8ON/STANDBY on the AV
receiver to light up the front display.
6
Select the USB input source.
“Now Initializing...” is displayed on the
front display and then the name of the
USB device is displayed. It takes 20 to
30 seconds to recognize the USB device.
7
Press RECEIVER followed by SETUP
on the remote controller.
The setup menu will be displayed on the
TV screen. The procedures thereafter can
also be performed on the AV receiver by
using its SETUP, arrow and ENTER
buttons.
8
Select “Hardware Setup” and press
ENTER.
9
Select “Firmware Update” and press
ENTER.
10
Select “Via USB” and press ENTER.
To Next Page
Loading...
Need help?
General
