EasyManuals Logo

Onkyo HT S5100 User Manual

Onkyo HT S5100
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
81
Advanced Setup
—Continued
Equalizer Settings
Here you can adjust the tone of individual speakers. To
set the volume of individual speakers, see page 80.
Notes:
The front, center, surround, and surround back speak-
ers can be adjusted at 80Hz, 250Hz, 800Hz, 2500Hz,
and 8000Hz. The subwoofer can be adjusted at 40Hz,
80Hz, and 160Hz.
While the Direct listening mode is selected, the equal-
izer settings have no effect.
This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
1
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “Equalizer, and
then press [ENTER].
3
Use the Left and Right [ ]/[ ]
buttons to select:
Off:
Tone off, response flat.
Audyssey:
The tone for each speaker
is set automatically by the
Automatic Speaker Setup
function. Be sure to select
this setting after having
performed the Automatic
Speaker Setup.
Manual:
You can adjust the equal-
izer for each speaker
manually.
If you selected Manual, continue with
this procedure. If you selected Off or
Audyssey, go to step 7.
4
Press the Down [ ] button, and
then use the Left and Right
[ ]/[ ] buttons to select a
speaker.
These settings are set automatically by the Automatic
Speaker Setup function (see page 42).
5
Use the Up and Down [ ]/[ ]
buttons to select a frequency.
Use the Left and Right [ ]/[ ]
buttons to adjust the level at that
frequency.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip:
Low frequencies (e.g., 63Hz,
80Hz) affect bass sounds; high frequen-
cies (e.g., 8000Hz, 16000Hz) affect tre-
ble sounds.
6
Use the Up [ ] button to select
“Ch, and then use the Left and
Right [ ]/[ ] buttons to select
another speaker.
Repeat steps 4 and 5 for each speaker.
Speakers that you’ve set to No or None
in the Speaker Configuration (page 77)
cannot be selected.
7
Press the [SETUP] button.
The setup menu closes.
HT-S5100En.book Page 81 Monday, May 19, 2008 1:47 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo HT S5100 and is the answer not in the manual?

Onkyo HT S5100 Specifications

General IconGeneral
BrandOnkyo
ModelHT S5100
CategoryHome Theater System
LanguageEnglish

Related product manuals