EasyManuals Logo

Onkyo HT-S5600 User Manual

Onkyo HT-S5600
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
Turning On & Basic Operations
En-35
You can display various information about the current
input source as follows.
The following information can typically be displayed.
*1
When AM or FM radio is used, the band, frequency, and preset
number are displayed.
*2
If the input signal is digital, the signal format is displayed.
Information is displayed for about three seconds, then the
previously displayed information reappears.
When you connect an u-capable Onkyo component, you
must configure the input display so that u can work
properly.
The Music Optimizer function enhances the sound quality
of compressed music files.
This section explains how to record the selected input
source to a component with recording capability.
AV Recording
Audio sources can be recorded to a recorder (e.g., cassette
tape deck, CDR, MD recorder). Video sources can be
recorded to a video recorder (e.g., VCR, DVD recorder).
Displaying Source Information
1
Press RECEIVER once followed by DISPLAY
repeatedly to cycle through the available
information.
Tip
Alternatively, you can use the AV receiver’s DISPLAY.
Input source
& volume
*1
Listening
mode
Signal
format
*2
or
sampling
frequency
Changing the Input Display
1
Change the name of the input selector to “DOCK”
or “TAPE”.
Tip
•SeeName” in “8. Source Setup” for changing the name
( page 44).
Note
•“DOCK” and “TAPE” cannot be selected for the input
selector at the same time.
Enter the appropriate remote control code before using the
remote controller for the first time ( page 54).
Using the Music Optimizer
1
Press MUSIC OPTIMIZER on the front panel.
The M.Opt indicator lights on the AV receiver’s
display.
Tip
Alternatively, you can use the remote controller’s HOME.
See “Music Optimizer” for more details ( page 48).
Using Headphones
1
Connect a pair of stereo headphones with a
standard plug (1/4 inch or 6.3 mm) to the PHONES
jack.
Note
Always turn down the volume before connecting your
headphones.
While the headphones plug is inserted in the PHONES
jack, the speakers are turned off. (The Zone 2 speakers are
not turned off.)
When you connect a pair of headphones, the listening mode
is set to Stereo, unless it’s already set to Stereo, Mono, or
Direct.
If you connect an iPod or iPhone to the USB port on the AV
receiver, no sound will be output from the headphones jack.
Recording
1
Use the input selector buttons to select the source
that you want to record.
You can watch the source while recording. The AV
receiver’s MASTER VOLUME control has no effect
on recording.
2
On your recorder, start recording.
3
On the source component, start playback.
If you select another input source during recording,
that input source will be recorded.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo HT-S5600 and is the answer not in the manual?

Onkyo HT-S5600 Specifications

General IconGeneral
BrandOnkyo
ModelHT-S5600
CategoryReceiver
LanguageEnglish

Related product manuals