Onkyo HT-S5600 User Manual

Advanced Operations
En-50
■ Operating on the AV receiver
■ Operating on the remote controller
To control Zone 2, you must press ZONE2 on the remote
controller first.
Adjusting the Volume for Zone 2
■ Operating on the remote controller
■ Operating on the AV receiver
If your Zone 2 speakers are connected to a receiver or
integrated amplifier in Zone 2, use its volume control to
adjust the volume.
Muting Zone 2
■ Operating on the remote controller
Tip
• To unmute, press ZONE2 followed by MUTING again. Zone can
also be unmuted by adjusting the volume.
Note
• Only analog input sources are output from the ZONE 2 LINE
OUT L/R jacks and ZONE 2 L/R terminals. Digital input
sources are not output. If no sound is heard when an input source
is selected, verify that the source is connected to an analog input.
• You cannot select different AM or FM radio stations for your
main room and Zone 2. The same AM/FM radio station will be
heard in each room. Namely, if you have selected an FM station
for the main room, that station will also be output in Zone 2.
• When you have selected USB as the input selector, the last
selector selected will be set for both Main room and Zone 2.
• When Zone 2 is activated and its input selector is selected, the
power consumption of standby mode slightly increases.
• While Zone 2 is on, u functions will not work.
• When setting the AV receiver to standby mode while Zone 2 is
active, the Z2 indicator is dimly lit.
• AUX cannot be selected as the input selector for Zone 2.
• When AUX is the input source of Main room and Zone 2 is set to
share the same source, no sound will be output from Zone 2.
Controlling Zone 2 Components
1
To turn on Zone 2 and select an input source, press
ZONE 2 followed by an input selector button
within 8 seconds.
Zone 2 turns on, the Z2 indicator lights on the
display.
To select the same source as the main room’s, press
ZONE 2 twice. “Z2 Sel: Source” appears on the AV
receiver’s display.
To turn off Zone 2, press OFF.
The zone is turned off.
ZONE 2 OFF MASTER VOLUME
8ON/STANDBY
Input selector buttons
8RECEIVER
MUTING
VOLq/w
ZONE2
Input selector buttons
1
Press ZONE2 and then press 8RECEIVER.
Zone 2 turns on, the Z2 indicator lights on the AV
receiver’s display.
2
To select an input source for Zone 2, press ZONE2,
followed by an input selector button.
3
To turn off Zone 2, press ZONE2 followed by
8RECEIVER.
The zone is turned off.
1
Press ZONE2.
2
Use VOL q/w.
1
Press ZONE 2 (the Z2 indicator on the AV
receiver’s display flash).
2
Use MASTER VOLUME control within 8 seconds.
1
Press ZONE2 followed by MUTING.

Onkyo HT-S5600 Specifications

General

Brand	Onkyo
Model	HT-S5600
Category	Receiver
Language	English