Onkyo K-611

Recording
If recording does not begin even when the steps listed under "Recording" are followed:
e@ Check to see if one or both of the cassette’s erasure prevention tabs have been broken off.
e@ Confirm that the cassette deck is properly connected to the amplifier and other components in the system.
Confirm that the amplifier is set up correct-
[Coy}) fo} ] ly for recording. (Refer to the amplifier’s
_ instruction manual for details.)
- ® Insert a cassette.
: Make sure the side to be recorded is
a facing outward.
-@ Prepare the source component to be
used for the recording.
e Tune in the desired station on the tuner.
e Load a CD (or LP) into the CD player
(or turntable).
e Load a cassette into the tape player
: (analog or DAT).
® Select the desired Dolby NR setting.
” Select the DOLBY B NR, DOLBY C
Example : NR or OFF position. (Referto page 11
FM for details.)
88.1 MHz : = ® Reset the Real Time Counter.
y * If desired, the MPX FILTER SWITCH
may be used when recording FM
broadcasts. (Refer to page IL for details.)
© Initiate play on the source com-
ponent,
® Press the REC/PAUSE button.
Illustrations enclosed in solid boxes
indicate source component operations.
RESET
ELAPSED } ft d td
© eae
MPX FILTER
OFF ON
©
pause
ap.
LAPSED
ae
ae
oe
a
10