Onkyo K-611 User Manual

To Play a Tape
ODD ®@ ©
@ Open the cassette holder.
® Insert a cassette.
e The portion of the cassette where the
tape is exposed sholud be facing
downward and the side on which you
wish to play facing outward.
® Close the cassette holder.
® Set the Dolby NR switch to the
proper position.
Set the switch to the B position if the
—_ == : } c
Loe | : q cassette to be played was recorded
fan ooh : \ ( ___using Dolby B NR. Use the C position
& OPEN/CLOSE
if the cassette was recorded using
2 Dolby C NR.
| ® Start Play
The auto-stop mechanism will auto-
: matically stop tape transport if a tape is
> : played through to the end.
play will begin at once.
@ When a cassette with the erasure
prevention tabs broken off (refer to
page 14, ‘‘Handling Cassette Tapes’’
for details) or a commercially produced
pre-recorded tape is loaded and the cas-
sette pushed lightly, the play indicator
8) 2 @ If the Play button is pressed after insert-
; S OPEN/CLOSE. TAPEIN, : ing a cassette into the holder, the cas-
: © 50 sette door will close automatically and
DOLBY NR
CH) flashes on and off and then play begins
(1) automatically. This capability is called
o-- the Auto Play function. If the cassette
door is left open for more than ap-
proximately five minutes, it closes auto-
matically. In this case the Auto Play
function does not operate
_ Automatic Tape SelectionSystem
This deck automatically detects the type of
cassette in the cassette holder and sets the
bias and equalization to the correct settings.
Tape selection is performed by detecting
the presence or absence of identification
- pits on the back of the cassette shell. Cas-
. settes manufactured before this id entifica-
Too 15 10-6 -3. 0 4346 1D _ tion system was adopted and bargain
" cassettes that do not incorporate these pits
cannot be used with this deck.
® ~ Neo
[J wes ELAPSED Li:
Boe
Stopping Playback =
Press the stop button.

Onkyo K-611 Specifications

General

Brand	Onkyo
Model	K-611
Category	Tape Deck
Language	English