Using
TV
Remote Controller
e Preprogrammed functions:
This
unit
has
been preprogrammed
so
that it
can
be
operated with your existing
TV
remote controller.
The
functions that
can
be operated
are
volume
control(+/-)
and muting
(~).If
you want to
use
other functions or cannot operate with your
TV
remote controller, you can
use
the learning function
as
below
to
enable the operation.
• The
mute
state can be turned over each
time
you press
the
Mute
button
on
your
TV
remote controller.
In
such
case,
you can synchronize
the
mute
status
of
the
unit
and the
TV
by pressing and holding
the
Mute
button
on your TV remote controller.
•
To
disable the preprogrammed function,
press
and hold first G, and then 0 for about
10
seconds. When
the
preprogrammed function
is
successfully disabled, D indicator
flashes 3 times, then any
TV
remote controller cannot be used
to
operate
the
unit. When
you
want
tore-enable
the
preprogrammed function, perform the same operation. When
the
preprogrammed function
is
successfully re-enabled, D indicator flashes once, then
you
can
use any remote controller using preprogrammed function.
To
control
the
preprogrammed functions: Varieties
ofTV
remote controllers have been
preprogrammed on this unit, which may lead
to
unintended operation from the other remote
controller than your
TV
remote controller. In
su
ch c
ase,
press and hold first G and then 0 and then
press
either volume or mute button on your
TV
remote controller 2 or 3 times
to
turn on
the
controlling
function. When the controlling function is set to on, the 0 indicator flashes twice, and then,
the
other remote controller cannot be operated.
• Controlling function may
not
be
set
to
some
TV
remote controllers.
•
To
cancel the controlling function,
press
and hold first G and
then[]
for
about
10
seconds. When
the
controlling function
is
successfully cancelled, D indicator flashes once, then you
can
use
an
y
remote controller using preprogrammed function.
e Learning function:
You
can operate the
unit
with
a TV remote controller by assigning
the
functions
to
the buttons
of
the
remote controller. Perform
the
following
button
operation,
when
the D indicator starts flashing, direct your
TV
remote controller
to
remote
control sensor
of
this
unit
and press the
button
to
assign
on
the TV remote controller 3 times.
When
the
Learning function
is
successfully set, Q indicator flashes twice.
*
Press
GJ
button
first
when
pressing and holding
the
buttons together.
ON/
S
TANDBY
VOLUME+
VOLUME
-
17
To Next Page
Loading...
Need help?
General
Weight and Dimensions
