of
the
following measures:
Reorient or relocate
the
receiving antenna.
Increase
the
separation between
the
equipment
and
receiver.
Connect
the
equipment
into
an
outlet
on a circuit
different from
that
to
which
the
receiver
is
connected.
Consult
the
dealer or
an
experienced radio/TV
technician for help.
This device complies
with
Industry Canada licenceexempt
RSS
standard(s). Operation
is
subject
to
the
following
two
conditions:
(1)
this device may
not
cause interference, and
(2)
this device must accept any interference, including
interference
that
may cause undesired operation
of
the
device.
This transmitter must
not
be co-located
or
operated
in
conjunction
with
any
other
antenna
or
transmitter.
RF
Exposure Compliance
This
equipment
complies
with
FCC/IC
radiation exposure
limits set forth for
an
uncontrolled environment and
meets
the
FCC
radio frequency
(RF)
Exposure Guidelines
in
Supplement C
to
OET65
and
RSS-1
02
of
the
\C
radio
frequency
(RF)
Exposure rules. This
equipment
has
very
low
levels
of
RF
energy
that
it
deemed
to
comply
without
maximum permissive exposure evaluation
(MPE).
But it
is
desirable
that
it should be installed and operated
keeping
the
radiator at least 20 em
or
more away from
person's
body
(excluding extremities: hands, wrists, feet
and ankles).
For Canadian Models
NOTE:
THIS
CLASS
B
DIGITAL
APPARATUS
COMPLIES
WITH
CANADIAN
ICES-003.
For
models having a
power
cord
with
a polarized plug:
CAUTION:
TO
PREVENT
ELECTRIC
SHOCK,
MATCH
WIDE
BLADE
OF
PLUG
TO
WIDE
SLOT,
FULLY
INSERT.
This
device complies with Industry Canada licence-exempt
RSS
standard(s). Operation
is
subject
to
the following
two
conditions:
(1)
this device may
not
cause interference, and
(2)
this device must accept any interference, including
interference
that
may cause undesired operation
of
the device.
For British models
Replacement and
mounting
of
an
AC
plug on
the
power
supply cord
of
this
unit
should be performed only by
qualified service personnel.
IMPORTANT
The wires
in
the
mains lead
are
coloured
in
accordance
with
the following code:
Blue: Neutral
Brown: Live
As
the
colours
of
the
wires
in
the
mains lead
of
this apparatus
may
not
correspond
with
the
coloured markings identifying
the terminals
in
your plug, proceed
as
follows:
The wire
which
is
coloured blue must be connected
to
the
terminal
which
is
marked
with
the
letter
Nor
coloured black.
The wire
which
is
coloured brown must be connected
to
the
terminal
which
is
marked
with
the
letter
Lor
coloured
red.
IMPORTANT
The
plug
is
fitted with
an
appropriate
fuse.
If the
fuse
needs
to
be
replaced,
the
replacement
fuse
must
approved
by
ASTA
or
BSI
to
BS
1362
and
have
the
same
ampere
rating
as
that
indicated
on
the
plug.
Check
for
the
ASTA
mark
or
the
BSI
mark
on
the body of the
fuse.
If
the
power
cord's plug
is
not
suitable for your socket outlets,
cut
it
off
and fit a suitable plug.
Fit
a suitable fuse
in
the
plug.
For European
Models
Declaration
of
Conformity
we
declare, under
our
sole responsibility,
that
( E
this
product
complies
with
the
standards:
Safety
Limits and
methods
of
measurement
of
radio disturbance characteristics
Limits for harmonic current emissions
Limitation
of
voltage changes, voltage fluctuations
and flicker
RoHS
Directive,
2011
/65/EU
Hereby, On kyo Corporation, declares
that
this
LS-B50
is
in
compliance
with
the
essential requirements and
other
relevant provisions
of
Directive 1999/5/EC.
Speaker Precautions
• Placement
•
The
subwoofer cabinet
is
made
out of wood
and
is
therefore
sensitive
to
extreme
temperatures
and
humidity, do not put it
in
locations
subject to
direct sunlight
or
in
humid
places,
such
as
near
an
air
conditioner, humidifier, bathroom,
or
kitchen.
•
Do
not put water or other liquids
close
to the
speakers.
If liquid
is
spilled over the
speakers,
the drive units
may
be
damaged.
•
Speakers
should only
be
placed
on
sturdy,
flat
surfaces
that
are
free
from vibration.
Putting them
on
uneven or unstable
surfaces,
where they
may
fall
and
cause
damage, will
affect the sound quality.
• Subwoofer
is
designed to
be
used
in
the
upright vertical position
only.
Do
not
use
it
in
the horizontal or tilted position.
• If the unit
is
used
near
a turntable,
CD
player
or
DVD
player,
howling or slipping
of
sound
may
occur.
To
prevent
this,
move the unit
away
from the turntable,
CD
player
or
DVD
player,
otherwise lower the unit's output
level.
• Use
with
a
TV
set
In
general,
Braun
tubes
used
for color television
sets,
etc.
are
extremely sensitive
and
can
be
affected
even
by
the magnetism of the earth. If
a
speaker
system
is
used
near
them, therefore,
discoloring or distortion
of
pictures will
occur.
These speakers are
not
provided with magnetic
shielding.
If discoloration or distortion
occurs,
move
the
speakers
apart from the television
set.
To Next Page
Loading...
