24
En
Volume +/– or Muting function works
by also pressing other buttons when
operating controller with your TV
remote controller
Pairing the controller and the
subwoofer
• If the controller is turned off or enters the standby
mode, also the subwoofer enters the standby mode
in 30 seconds. In this mode, the controller
automatically detects a pairing point and
reconnects. The subwoofer is automatically turned
on when the link is recovered.
• Depending on the reception condition, the sound
might be stopped or interrupted while using. This is
not a malfunction. In this case, change the place or
direction of the controller or the subwoofer.
• If the controller and the subwoofer are too far, the
reception might be unstable. They should be placed
within 32 ft. (10 m).
• If there is an obstacle (metal door, concrete wall and
insulation contained aluminum foil, etc.) between
the controller and the subwoofer, it might block the
reception and stop the sound. Place the controller
and the subwoofer in good visibility with each
other.
• Use the controller and subwoofer included together
in the package. No other devices can be combined.
For some TV remote controller,
Volume +/– or Muting function might
work by also pressing other buttons.
(Volume is increased by pressing 0
(number button), etc.) In order to
prevent incorrect operation, use the
controller to configure volume control
and muting buttons on the TV remote
controller. In addition, disable TV
remote controller operation.
21
Others
Turn on the controller before performing
a pairing.
1
Press and hold LINK on the rear panel of
the subwoofer for five seconds.
Flashing speed of the LINK LED is
changed.
2
Press and hold ÍON/STANDBY on the
controller for three seconds until the
ON/STANDBY LED flashes white.
The controller and the subwoofer starts
pairing. The ON/STANDBY LED flashes
white twice indicating that the pairing is
completed.
The controller contains a microcomputer for
signal processing and control functions. In
very rare situations, severe interference,
noise from an external source, or static
electricity may cause it to lockup. In the
unlikely event that this happens, unplug the
power cord from the wall outlet, wait at least
five seconds, and then plug it back in.
Before disconnecting the power cord from
the wall outlet, set the controller to standby.
LS3200_En.book 24 ページ ２０１５年５月１３日 水曜日 午後５時５１分
To Next Page
Loading...
Need help?
General
