En-19
3
Press the PAIRING button on the sound bar.
4
Hold the device over the NFC mark on the upper surface
center of the sound bar.
•
The Bluetooth indicator on the sound bar is changed from flashing
to lighting, indicating that the pairing is complete.
•
Some types of devices do not require step 2.
•
Some devices such as smartphones sound alarms when they recognize NFC enabled
devices. If the device is moved at this timing, connection or disconnection may not
be performed. Do not move the device until a message “Connection is completed” or
“Disconnection is completed” is displayed on it.
Listening to the sound
Check that:
-
Bluetooth function of the source device is on.
-
Pairing of the sound bar and the source device is completed.
1
Press the INPUT button to select Bluetooth function.
2
Start the Bluetooth connection from the Bluetooth enabled device.
3
Start playing on the Bluetooth enabled device.
•
If the source device has an extra bass function or equalizer function, set them to off. If these
functions are on, sound may be distorted.
Note
•
You need to make the Bluetooth connection again if:
- the sound bar is not turned on.
- the source device is not turned on, or its Bluetooth function is off or is in sleep mode.
To finish listening
Perform any of the followings.
- Terminate the Bluetooth connection on the audio source device. (Refer to the instruction manual of
the source device.)
- Turn off the Bluetooth enabled devices.
- Turn off the sound bar.
Note
•
Some Bluetooth enabled devices cannot be operated with the remote controller.
•
The volume of the sound bar may not be controlled as intended depending on the connected device.
Bluetooth operation buttons (remote controller only)
Press the button to play or pause.
Press the button to skip up. Hold down it to fast-forward.
Press the button to skip down. Hold down it to fast-reverse.
To Next Page
Loading...
Need help?
General
