Onkyo TA-6510 User Manual

Useful Functions (Repeat Mode)
REPEAT NS oY
FULL
Y
\
me PLAY
BLOCK
ii \
\\ 4
4, \
,
BLOCK
Mf Ww
3) (b) This section is @
repeated five times.
tS
@)
begining
of tape
end of
tape
11
"Two repeat modes are available: full and
_ block.
REPEAT ® PLAY
Full
_ Use this mode to repeat an entire cassette
. side up to five times.
@ Press the REPEAT button once.
The FULL indicator lights.
@ Pressthe ™ PLAY button.
The cassette side will be repeated up to
five times.
e The repeat function can be activated by
pressing the REPEAT button once e1-
ther before or after the P PLAY but-
ton, It is therefore possible to activate
the repeat play mode as a tape is being
_BlockRepeat = =>
~ Use this mode to repeat a selection or a spe-
~ cific section up to five times.
~ @ Press the REPEAT button twice.
The BLOCK indicator lights.
Dee - @ Pressthe »™ PLAY button to begin
playback. The BLOCK indicator
flashes on and off.
_@® When the tape reaches the beginning
of the block you wish to repeat, press
the »™ PLAY button once again.
This marks the beginning of the
block to be repeated.
e To change the beginning point of the
block to be repeated, press the »
PLAY button again.
. 7 © When the end of the block to be re-
peated is reached, pressthe <<
button. The BLOCK indicator
lights continuously.
The portion of the tape between the point
_ where the ® PLAY button was pressed
and the point where the <4 button was
pressed will be played five times in succes-
“sion. After the fifth time, tape transport
halts at the point at which the <4 button
was pressed.
e Itis also possible to start the repeat
mode by pressing the REPEAT button
while the tape is running.

Onkyo TA-6510 Specifications

Power

power supply rating (UK and Australian models)	AC 240 V 50 Hz
power supply rating (European models except UK)	AC 230 V, 50Hz
power supply rating (Worldwide models)	AC 120 and 220 V, Switchable 50/60 Hz
power consumption	13 watts

Audio Specifications

frequency response (normal)	20–18, 000 Hz
frequency response (high)	20–19, 000 Hz
frequency response (metal)	20–20, 000 Hz
signal-to-noise ratio	60 dB (metal tape, Dolby NR off)

Input and Output

input sensitivity	80 mV
input impedance	50 kohms
standard output level	500 mV
optimum load impedance (output)	over 50 kohms
optimum load impedance (headphone jack)	8 to 200 ohms

Weight and Dimensions

weight	5.0 kg
dimensions	455(W) x 120(H) x 310(D) mm