Onkyo TA-6510 User Manual

Playing Tapes
Cassette holder m PLAY
EJECT DOLBY NR
@) ooo @ Press the EJECT button to open the
EJECT ————> : cassette holder.
ca _ @ Inserta cassette.
(Se) - @ The portion of the cassette where the
tape is exposed sholud be facing down-
ward and the side you wish to play fac-
ing outward.
Close the cassette holder.
Select the appropriate Dolby NR
mode using the Dolby NR button.
Each press of the Dolby NR button ad-
vances the Dolby NR mode setting one
step through the following sequence:
B, C, OFF, B, etc.
Select the B setting if the cassette to be
played was recorded using Dolby B
3) $$ NR. Use the C setting if the cassette
was recorded using Dolby C NR.
Tapes recorded without Dolby NR
must be played back using the OFF
setting.
_® Press the m play button to begin
| playback.
co Pr ee 7 The Peak Level indicators will light
during playback showing the strength
(4)
of
the
recorded
signal.
®oO
~N oN “oN The auto-stop mechanism will auto-
povey NR _—> —>|OFF matically stop tape transport if a tape is
cS y . YY \ 4 \ played through to the end.
‘ e The TAPE indicator lights when power
is initially turned on. If the B play
button is pressed while SOURCE 1s lit,
the indicator switches to TAPE auto-
6)
matically.
mr
PLAY
—
OPERATION
5
REPEAT
——
~
COLBY
NR
=
~
EOUNTER
®
The
position
of
the
ACCUBIAS
knob
PSED Pde ;
[ m Fr m bilo | has no effect on playback sound quality.
COSTCO
aiaanadaaaanaaaaaiaianaaaaaTaaaAaaNNaaMTTa
:
_
Automatic
Tape
Selection
QOAUMEYDOQULYUODUCYDECLILSUUUQGUQUOEXELEINENOCOLOQUQOUIGOOE woe System |
This deck automatically detects the type of
cassette in the cassette holder and sets the
bias and equalization to the correct settings.
Tape selection is performed by detecting
the presence or absence of identification
pits on the back of the cassette shell. Cas-
settes manufactured before this identifica-
tion system was adopted and bargain
cassettes that do not incorporate these pits
cannot be used with this deck.

Onkyo TA-6510 Specifications

Power

power supply rating (UK and Australian models)	AC 240 V 50 Hz
power supply rating (European models except UK)	AC 230 V, 50Hz
power supply rating (Worldwide models)	AC 120 and 220 V, Switchable 50/60 Hz
power consumption	13 watts

Audio Specifications

frequency response (normal)	20–18, 000 Hz
frequency response (high)	20–19, 000 Hz
frequency response (metal)	20–20, 000 Hz
signal-to-noise ratio	60 dB (metal tape, Dolby NR off)

Input and Output

input sensitivity	80 mV
input impedance	50 kohms
standard output level	500 mV
optimum load impedance (output)	over 50 kohms
optimum load impedance (headphone jack)	8 to 200 ohms

Weight and Dimensions

weight	5.0 kg
dimensions	455(W) x 120(H) x 310(D) mm