Onkyo TA-6510 User Manual

a8 PAUSE
@ STOP
tt PAUSE
_ Press the stop button.
[| _ Press the 18 PAUSE button.
ree . @ To resume paly, press the
y- play button.
- fore using the fast forward or rewind func-
> tion.
- To rewind the tape, press the <4 button.
- To advance the tape, press the pp but-
ton.
Q e “ @ To stop either fast forward or rewind,
—_ : press the Mi STOP button.
a
()
©
>
O
(O}
Make
sure
the
unit
is
in
the
stop
mode
be-
-
®
O
m PLAY
_ The tape must be playing in order to use
- this function.
Fo . Press the »». button to skip ahead to the
_ next selection. It is possible to skip up to
. 7 as So ae DEE PR Mth tf ouienap eau tetoacect” 15 selections at one time. The number of se-
~ lections skipped is indicated by the display
~ (PI, P2... P15).
~ When the target selection is reached, nor-
~ mal play resumes.
T
_ this function.
_ Press the <4 button to skip back to the
- beginning of the currently playing selection
-.-- Or preceding selections. The number of se-
_ lections skipped is indicated by the display.
(PI, -P2... -P15)
When the target selection is reached, nor-
mal play resumes.
Note:
The skip function operates by detecting the
sections on the tape between selections
where nothing is recorded. Therefore, it
may not operate properly under circum-
~~
stances
such
as
the
following:
C_]
1)
If
the
blank
sections
between
selections
are
too
short.
2) If the music is not continuous, being in-
terrupted by narration, etc.
3) If there are places in the music that
could be mistaken for breaks between
selections, such as soft sections imme-
diately followed by loud sections.
4) If there is excessive noise in the por-
tions between selections.

Onkyo TA-6510 Specifications

Power

power supply rating (UK and Australian models)	AC 240 V 50 Hz
power supply rating (European models except UK)	AC 230 V, 50Hz
power supply rating (Worldwide models)	AC 120 and 220 V, Switchable 50/60 Hz
power consumption	13 watts

Audio Specifications

frequency response (normal)	20–18, 000 Hz
frequency response (high)	20–19, 000 Hz
frequency response (metal)	20–20, 000 Hz
signal-to-noise ratio	60 dB (metal tape, Dolby NR off)

Input and Output

input sensitivity	80 mV
input impedance	50 kohms
standard output level	500 mV
optimum load impedance (output)	over 50 kohms
optimum load impedance (headphone jack)	8 to 200 ohms

Weight and Dimensions

weight	5.0 kg
dimensions	455(W) x 120(H) x 310(D) mm