Onkyo TX-3000 - SPECIFICATIONS; AMPLIFIER SECTION; TUNER SECTION; GENERAL SPECIFICATIONS

TX-3000
SPECIFICATIONS
AMPLIFIER SECTION
Output Power: 45 watts per channel, min. RMS, Signal-to-Noise Ratio: Mono: 70 dB
at 8 ohms both channels driven, Stereo: 65 dB
from 20 Hz to 20,000 Hz, with Alternate Channel Att: 60dB
no more than 0.04% total AM Suppression Ratio: 52 dB
harmonic distortion. Harmonic Distortion: Mono: 0.15%
Total Harmonic
Stereo: 0.3%
Distortion: 0.04% at rated power Frequency Response: 30 Hz — 15,000 Hz (41.5 dB)
0.04% at 1 watt output Stereo Separation: 40 dB at 1 kHz
IM Distortion: 0.1% at rated power . 30 dB at 100 Hz — 10,000 Hz
0.04% at 1 watt output Muting Level: 14.7 dBf, 3 uV
Damping Factor: 40 at 8 ohms Stereo Threshold: 14.7 dBf, 3 pV
Frequency Response: 20 Hz — 30,000 Hz (+1 dB) Servo Lock Level: 14.7 dBf, 3 pV
RIAA Deviation:
Sensitivity & Impedance:
20 Hz — 20,000 Hz (+0.8 dB)
Phono: 2.5 mV, 50 kohms
Tape Play: 150 mV, 50 kohms
AM:
Tuning Range: 325 — 1,620 kHz
Tape Rec: 150 mV, 3.5 kohms Usable Sensitivity : 2) wv
(PH) | Image Rejection Ratio: 45 dB
Phono Overload: 180 mV r.m.s. at | kHz, 0.04% IF Rejection Ratio: 30 dB
THD. Signal-to-Noise Ratio: 40 dB
Signal-to-Noise Ratio: Phono: 85 dB (at 10 mV input Harmonic Distortion: 0.8%
IHF A weighted) GENERAL
_ 65 dB CHF C weighted) power Supply: AC 120 volts, 60 Hz (D model)
Tape: 95 dB (IHF A welgnen AC 220 volts, 50 Hz (G model)
| | 90 dB (IHF C weighted) AC 220/120 volts, 50/60 Hz
Residual Hum & Noise: 0.8 mV at Volume Control: min.
Tone Controls: Bass: +12 dB at 100 Hz (W model)
one
WONMTONS:
ss
;
+12
d
10
ki
Outputs:
Speaker
A
&
B,
Phones,
Tape
—_ Treble: 7 oB at 10 kHz Rec Out 1 & 2, AC Outlet (x 2)(D model)
High Filter: 6 kHz (6 dB/oct) Inputs: Phono, Tape Play | & 2
Loudness (—30 dB): +9 dB at 40 Hz FM and AM An tennas
+5 dB at 20 kHz Antennas: FM: 300 ohms balanced and
75 ohms unbalanced
TUNER SECTION AM: _ built-in ferrite core
FM: antenna and external
Tuning Range: 88 — 108 MHz (D model) terminal
87.5 MHz — 108 MHz Semiconductors: I FET, 20 transistors, 11 ICs,
(G/W model) 38 diodes (D & W model)
Usable Sensitivity: Mono: 11.2 dBf, 2 uv 1 FET, 22 transistors, 11 ICs,
Stereo: 19.2 dBf, 5 uV 38 diodes (G model)
50 dB Quieting Dimensions (W x Hx D): 480 x 130 x 376mm
Sensitivity : Mono: 17.2 dBf, 4 uV 19” x 5-1/8” x 14-13/16”
Stereo: 37.2 dBf, 40 uv Weight: 11.4 kg, 25.1 Ibs
Capture Ratio: 1.5 dB
Image
Rejection
Ratio:
60dB
Specifications
and
features
are
subject
to
change
without
notice.
IF Rejection Ratio: 85 dB
Spurious Rejection Ratio: 85 dB
COMPONENT LOCATION
slowole
©) |) \& |G ©
Wht
Back View