Onkyo TX-8210 - Schematic Diagram (Part H)

Receiving RDS (Only for TX-8210R)
Press the PT Y/TP button, to select “PTY”.
If the station you are receiving is not broadcasting RDS, “Not
RDS” (this is not an RDS station) will be shown on the display.
Use the < DOWN TUNING UP > buttons to select the pro-
gram type (PTY) (for example, “ROCK M”’’).
See the PTY description on the previous page.
Press the SCAN button to start searching for the chosen
PTY station. When a station is received with the desired PTY,
the scanning stops for approximately 5 seconds, before the unit
starts scanning again.
When the desired station is reached, press SCAN button
again to stop scanning.
1, Press the PTY/TP button to select “TP”.
If * 7% is shown on the display, it indicates that the current
Station 1s broadcasting traffic information.
2. Press the SCAN button to start searching for a TP station.
When the unit receives a TP station, it stops scanning. If the
unit cannot receive any TP station, “Not find” (cannot find the
station) is shown on the display.
If the station you are listening to is not an RDS station, this func-
tion cannot be used.
1. Each time you press the DISPLAY button, the display
changes as follows.
Frequency , Character or Program
Service Name
Radio Text ——__]
If the current station you are listening to is not an RDS station,
only the frequency of the station and the characters (see pages 17)
appears. (If there have been no characters entered, only the fre-
quency is shown.)
When RT is received, it can sometimes take up to 15 seconds (more
or less) to show RT on the display.
Sometimes the following messages will be shown on the display.
Wait: When the information is received, the characters will scroll
across the display.
No text: this appears for 3 seconds and indicates that even though
an RDS station is being received, there is no RT information
included,
|
9