Onkyo TX-8210 - Microprocessor Connection Diagram

Making system connections
e Do not plug in the power cord until all connections have been made.
@ On each pair of input jacks, the lower jack (marked R) corresponds to the right channel, and the upper jack (marked L) to the
left channel.
e Please refer to the instruction manual of each component when making any connections.
C.J coo &
Connect the output leads of the turntable to
the PHONO jacks.
Be sure to connect the ground (earth) lead
wire from the turntable to the ground ter-
minal (GND). Turntables not provided
with GND wires do not need to be con-
nected in this way.
Place the turntable on a firm shelf or deck
free from vibrations (especially those gen-
erated by the speaker system). If the turnta-
ble can pick up such unwanted vibrations,
not only will the performance of the unit
drop, but distortion in the bass frequencies
and howling in the speakers may also
occur.
Connect a compact dise player to the CD
input jacks.
Two tape decks can be connected to this
unit.
If you are using only one tape deck, con-
nect it to the TAPE-1/VIDEO jacks. If you
have two tape decks, connect one to the
TAPE-1/VIDEO jacks and the other to the
TAPE-? jacks.
If you wish to use a graphic equalizer as
well as two tape decks;
1. Connect the graphic equalizer to the
TAPE-2 jacks.
2. Connect the second tape deck to the
tape jacks on the graphic equalizer.
3. Press the TAPE-2 MONITOR button
on this unit's front panel. To record an
equalized signal, use tape deck 2 (con-
nected to the equalizer) for recording.
For the audio signal of a VDP, VCR,
etc., make the connections using the
TAPE-1/VIDEO “PLAY” jacks.
For details, refer to the operating tnstruc-
tions of the graphic equalizer and video
equipment concerned.