Onkyo TX-8210 - Parts List

Before using this unit
(Worldwide models only)
(Bottom)
Remote contro! sensor
sae
VOLTAGE SELECTOR
ot J
Tuning step frequency switch
TX-8210/R
approx. 5m
Bocca
See
UE SRE
Worldwide models are equipped with a
voltage selector on the rear panel.
i.
tr
Determine the proper voltage for your
area: 220V or 120V.
If the preset voltage is not correct for
your area, insert a screwdriver into the
groove in the switch. Slide the switch
all the way to the right (120V) or to the
left (220V), whichever is appropriate.
Worldwide models are equipped with a
switch that controls the AM band tuning
steps.
Please set this switch to match the AM
band tuning step frequency in your area.
U.S.A. and Canada : |0kHz
Other areas : 9kHz
Average battery life is about one year,
depending upon the frequency of use and
the environment (temperature and humid-
ity) in which the remote control is used.
Only use batteries of the kind specified in
the table below.
Warning
Do not leave an expired battery in the
case — it may leak or damage the remote
control.
Do not use nickel cadmium (recharge-
able) batteries.
Replace both batteries at once: do not
use one old battery and one new battery.
The following information will help you
get optimal use from the remote control.
@ Place this unit away from direct bright
light, which can prevent proper opera-
tion of the remote control.
Make sure audio rack doors do not have
tinted glass. If this unit is placed behind
such a door. this may prevent proper
remote control operation.
Using other remote controls in the same
room as this unit’s remote control may
cause Interference.