Onkyo TX-SR494

93
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
 ZONE B function
❏ Cannot ZONE B-output the audio of externally connected AV components
• To output audio to ZONE B, set the audio output destination to "ZONE A+B" or "ZONE B". ( p46)
 Remote Controller
• Make sure that the batteries are inserted with the correct polarity.
• Insert new batteries. Do not mix di󰀨erent types of batteries, or old and new batteries.
• Make sure that the sensor of the main unit is not subjected to direct sunlight or inverter-type uorescent lights. Relocate it if necessary.
• If the main unit is installed in a rack or cabinet with colored-glass doors, or if the doors are closed, the remote controller may not work normally.
 Display
❏ The display does not light up
• When the Dimmer function is working, the display may go dim. Press the DIMMER button, and change the brightness level of the display. ( p9)
 Others
❏ Strange noise can be heard from the unit
• If you have connected another device to the same outlet as this unit, strange noise may occur under the inuence of the device. If the symptom is
remedied by removing the power plug of the other device from the outlet, use di󰀨erent outlets for this unit and the device.
❏ The message "Noise Error" appears during AccuEQ Room Calibration
• This can be caused by a malfunction in your speaker unit. Check the speaker output, etc.
❏ The measurement results of AccuEQ Room Calibration show di󰀨erent distances to the speakers from
the actual ones
• Depending on the speakers you are using, some errors may occur in the measurement results. If this is the case, make the settings in
"2. Speaker" - "Distance" in the Setup menu.
( p73)