Onkyo TX-SR494DAB - Setup; Switching HDMI 4 K Signal Format

68
Setup
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Switching the HDMI 4K Signal Format Input and Output by this Unit
When the AV Component connected to this unit, such as a TV or player, and the
HDMI cable (*) supports the high-denition 4K signal formats (4K 60p 4:4:4, 4:2:2
and 4K 60p 4:2:0 10bit), switch the setting value from "Standard" (default value)
to "Enhanced".
(*)Premium High Speed HDMI Cable or Premium High Speed HDMI Cable
with Ethernet that have the "PREMIUM Certied Cable" label attached to the
packaging.
Perform the following procedure when the unit is on.
1. While pressing BD/DVD on the main unit, press ON/STANDBY to display the
current setting on the display. While this is being displayed, while pressing BD/
DVD on the main unit, repeatedly press ON/STANDBY to switch the setting.
Standard
(Default
Value)
Select when the AV component connected to this unit,
such as a TV or player, supports the standard 4K signal
format (4K 60p 4:2:0 8 bit).
Enhanced
Select when the AV component connected to this unit,
such as a TV or player, and the HDMI cable (*) supports
the high-denition 4K signal formats (4K 60p 4:4:4, 4:2:2
and 4K 60p 4:2:0 10 bit).
• There may be some image disruption depending on
the connected component and the HDMI cable. If this
occurs, switch to "Standard".
2. To exit the settings, release your nger. After a few seconds, the display goes
out and the switching is complete.
Settings and the corresponding resolutions
Enhanced Standard
4K (3840×2160p) 24/25/30 Hz
4K SMPTE(4096×2160p) 24/25/30 Hz
RGB/
YCbCr4:4:4
8 bit
10/12 bit
YCbCr4:2:2 12 bit
4K (3840×2160p) 50/60 Hz
4K SMPTE(4096×2160p) 50/60 Hz
RGB/
YCbCr4:4:4
8 bit
YCbCr4:2:2 12 bit
YCbCr4:2:0
8 bit
10/12 bit