Onkyo TX-SR494DAB - Hardware Settings

82
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
5. Hardware
 1. HDMI
Change the settings of the HDMI function.
Setting Item Default Value Setting Details
HDMI CEC O󰀨 Setting this to "On" enables the input selection link
and other link functions with HDMI-connected CEC-
compatible device.
"On": When this function is used
"O󰀨": When this function is not used
When this setting is changed, turn o󰀨 and then on
again the power of all connected devices.
• Depending on the TV to use, a link setting may
be required on the TV.
• Setting this to "On" and closing the operation
screen will display the name of the connected
CEC-compatible device and "CEC On" on the
main unit’s display.
• When this is set to "On", the power consumption
in standby mode may increase. (Depending
on the TV status, the unit will enter the normal
standby mode.)
• If you operate the MASTER VOLUME dial on the
main unit when this setting is "On" and audio is
output from the TV speakers, audio will be output
also from the speakers connected to this unit. To
output audio from only either of them, change the
setting of this unit or TV, or reduce the volume of
this unit.
• If abnormal behavior is observed when this is set
to "On", set it to "O󰀨".
• If a connected device is not CEC-compatible, or
if you are not sure whether it is compatible, set
it to "O󰀨".
Setting Item Default Value Setting Details
HDMI Standby
Through
O󰀨 When this is set to anything other than "O󰀨",
you can play the video and audio of an HDMI-
connected player on the TV even if the unit is in
standby mode. Also, only "Auto" and "Auto(Eco)"
can be selected if "HDMI CEC" is set to "On". If you
select anything else, set "HDMI CEC" to "O󰀨".
• The power consumption in standby mode will
increase if it is set to anything other than "O󰀨".
"BD/DVD", "GAME", "CBL/SAT", "STRM BOX",
"PC", "CD", "TV": For example, if you select "BD/
DVD", you can play the device connected to
the "BD/DVD" jack on the TV even if the unit is
in standby mode. Select this setting if you have
decided which player to use with this function.
"Last": You can play on the TV the video and audio
of the input selected immediately before the unit is
switched to standby.
"Auto", "Auto (Eco)": Select either of the settings
if the connected player conforms to the CEC
standard. You can play the video and audio of
the player on the TV using the CEC link function,
irrespective of what input is selected immediately
before the unit is switched to standby.
• To play a non-CEC compliant player on the TV,
turn the unit on and switch the input.
• When using a CEC-compliant TV, you can
reduce the power consumption in standby mode
by selecting "Auto (Eco)".