Important Safeguards--Continued
21. Replacement Parts When replacement parts are required, be
sure the service technician has used replacement parts specified
by the manuf_acturer or have the same characteristics as the orig-
FIGURE 1:
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE, ANSI/NFPA 70
inal part. Unauthorized substitutions may result in fire, electric
shock, or other hazards.
22. SatYty Check Upon completion of any service or repairs to
the appliance, ask the service technician to perfolm safety
checks to determine that the appliance is in proper operation
condition.
23. Wall or Ceiling Mounting The appliance should be mounted
to a wall or ceiling only as recommended by the manut_acturer.
24. Heat 'I'he appliance should be situated away fi-om heat
sources such as radiators, heat registers, stoves, or other appli*
ances (including amplifiers) that produce heat.
25. Liquid Hazards The appliance should not be exposed to
dripping or splashing and no objects filled with liquids, such as
vases should be placed on the appliance.
Precautions
_ POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250 PART H)
For British models
P,eplacement and mounting of an AC plug on the power supply cord
of this unit should be performed only by qualified service personnel.
IMPORTANT
The wires in the mains lead are coloured in accordance with the
following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
IMPORTANT
A 5 ampere fuse is fitted in this plug. Should the fuse need to be
replaced, please ensure that the replacement fuse has a rating of 5
amperes and that it is approved by ASTA or BSI to BS 1362. Check
for the ASTA mark or the BSI mark on the body of the fuse.
IF THE FITTED MOULDED PLUG IS UNSUI'IABLE FOR THE
SOCKET OUTLET IN YOUR HOME THEN THE FUSE
SHOULD BE REMOVED AND THE PLUG CUT OFF AND DIS-
POSED OF SAFELY. THERE IS A DANGER OF SEVERE ELEC*
TRICAL SHOCK if THE CUT OFF PLUG IS INSERTED INTO
ANY 13 AMPERE SOCKE'I_
If in any doubt, consult a qualified electrician.
For European Models
Declaration of Conformity
We, ONKYOEUROI_E (
ELECTRONICS GmbH
LIEGNITZERSTRASSE
6, 82194 GROEBENZELL,
GERMAN Y
declare in own responsibility, that the ONKYO product described
in this instruction manual is in compliance with the corresponding
technical standards such as EN60065, EN55013, EN55020 and
EN 61000_3-2, -3 -3. j j
GROEBENZELL, GERMANY
g_/ I_aORI
ONKYO EUROPE ELECTRONICS GmbH
NEC NATIONAL ELECTRICAL CODE
$2898A
For U.S. models
Note to CATV system installer:
This reminder is provided to call the CATV system installer's atten-
tion to Section 820-40 of the NEC which provides guidelines for
proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding system of the building, as close
to the point of cable entry as practical.
FCC lntbrmation fbr User
CAUTION:
The user changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruc-
tions, may cause harmftd interference to radio commtmications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause hmTaful inter-
ference to radio or television reception, which can be detmrnined by
turning the eqtdpment offand on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult tfie dealer or an experienced radio/TV technician for help.
For Canadian Models
NOTE: THIS CLASS B DIGITAL APPARATUS COMPLIES
WITH CANADIAN ICES-003.
For models having a power cord with a polarized plug:
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLO'I\ FULLY INSERT.
Modele canadien
REMARQUE: CET APPAP, EIL NUMERIQUE DE LA
CLASSE BEST CONFORME A LA NORME NMB-003 DU
CANADA.
Sur les modules dont la fiche est polaris_e:
ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES,
INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE
DANS LA BORNE CORRESPONDANTE DE LA PRISE ET
POUSSER JUSQU'AU FOND.
3
To Next Page
Loading...
